DTVS T1 Betriebsanweisung PDF herunterladen (Seite 13)

First Time Installation

After all the connections have been made

properly, switch on your TV, make sure the

receiver is connected to the mains.

If you are using the receiver for the rst time

or restored to factory default, the Welcome

Screen will be displayed.

The Welcome Page will allow you to enter the

Aspect ratio, Antenna Power and LPM standby

values as described below:

Aspect Ratio: Set the ratio of the picture. 16:9 is normally used for wide screen televisions and 4:3 for

square televisions.

Antenna Power: When set to on, the set top box will send 5V DC to the antenna.

LPM in stand-by: When set to on, the receiver will operate in low power mode when placed in

standby.

Press the OK button to begin the scanning of channels.

Switch Program

1. Press the numeric buttons (0~9) on the remote control to select the channel you want.

2. Press the P+/- buttons on the remote control or the front panel to change the available channels

up and down.

3. Press the BACK button to view the previous channel selected.

Volume Control

• Press the V+/- button on the remote control

or front panel to adjust the volume and the

volume bar will be displayed.

• Press the button to switch the sound o. If you want to cancel this function, you can press the

button again or press the V+/–.

Text

• Press the TEXT button to enter MHEG if MHEG is transmitted.

• Press the TEXT button again or press the EXIT button to exit the MHEG (TV mode).

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

Keine Kommentare

DTVS T1 Betriebsanweisung Seite 13